Kingston 16GB (2 x 8GB) DDR3L 1600MHz HyperX Impact SODIMM (HX316LS9IBK2/16)


Availability: Out of Stock

8GB DDR3 SODIMM | 1600Mhz | 2 x 8GB Kit
Product Description

Product Description

Kingston 16GB DDR3 Hyperx Impact

HyperX HX316LS9IBK2/16 is a kit of two 1G x 64-bit (8GB)
DDR3L-1600 CL9 SDRAM (Synchronous DRAM) 2Rx8, low
voltage, memory modules, based on sixteen 512M x 8-bit DDR3
FBGA components per module. Total kit capacity is 16GB.
Each module kit has been tested to run at DDR3L-1600 at a
low latency timing of 9-9-9 at 1.35V or 1.5V. Additional timing
parameters are shown in the PnP Timing Parameters section
below. The JEDEC standard electrical and mechanical specifications
are as follows:


• JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~
1.575V) Power Supply
• VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)
• 800MHz fCK for 1600Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 11, 10, 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
• Bi-directional Differential Data Strobe
• Internal(self) calibration : Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB : Height 1.180” (30.00mm), double sided component


Additional Information

Product SKU KIN00008
Model HX316LS9IBK2/16
Condition New

CL(IDD) 9 cycles
Row Cycle Time (tRCmin) 48.125ns (min.)
Refresh to Active/Refresh 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) 33.75ns (min.)
Maximum Operating Power TBD W* @1.35V
UL Rating 94 V - 0
Operating Temperature 0o
C to 85o C
Storage Temperature -55o
C to +100o C
*Power will vary depending on the SDRAM used.
16GB (8GB 1G x 64-Bit x 2 pcs.) DDR3L-1600
CL9 204-Pin SODIMM Kit
Continued >>
• DDR3-1600 CL9-9-9 @1.35V or 1.5V
• DDR3-1333 CL8-8-8 @1.35V or 1.5V
• DDR3-1066 CL6-6-6 @1.35V or 1.5V
Note: The PnP feature offers a range of speed and timing options to support
the widest variety of processors and chipsets. Your maximum speed will
be determined by your BIOS.

Warranty Limited Lifetime Warranty